The DB600 tank divider makes it easy to:

• Run multiple batches of parts at the same time
• Run multiple media sizes and/or shapes at the same time
• Reduce part impingement on soft materials
• Made in the USA
• Easy to install at any location
• Simple and sturdy design and construction

Installation

• Simply decide where you want the divider to be located for your application
• Place the divider in the chosen location
• Ensure the notched end at the top fits around the spray bar that runs across the back of the tank 
• The divider is not meant to sit in between the ribs of the liner
• It should sit on top of the ribs and have a snug fit
• Occasionally the divider may be slightly oversized and difficult to fit.
• In this case lightly sand the edges of the divider until it can be put in place.
• Mark holes to be drilled
• Drill two 5/16” holes
• After drilling holes, fasten in place with included nuts and bolts.
• Note: The set of three pre-drilled holes are used for the sound abatement cover attachment and are not meant for divider mounting

Download Instructions

*Note The Mr Deburr tanks have natural slight variations due to the urethane liner properties. For this reason the divider assemblies will not have an air or liquid tight fit.

**Note Small millimeter sized medias such as porcelain spheres or small parts may pass through or become lodged between the divider and liner in some cases.