DB600 Shaft Pulley Replacement

NOTE: You will also need the pulley bushing H 1 7/16 to fit it to the drive shaft. If you don't have this available on your current machine please contact us directly at info@cmtopline.com

 *C&M Topline does not warranty bearing service performed by customer or any other third part. Replacement of any DB600 bearing assembly component requires a detailed understanding of the assembly. The complete bearing assembly weights approximately 70 lbs. To best remove an assembly for service and replacement it is recommended that the base plate and tank be disconnected from the base assembly springs and inverted. This allows for a upright work bench to perform service with adequate access and to re-install the bearing assembly with proper spacing to the base plate block mounting holes. Contact us for more information.