The DB300 tank divider makes it easy to:

Run multiple batches of parts at the same time
Run multiple media sizes and/or shapes at the same time
Reduce part impingement on soft materials
Made in the USA
Easy to install at any location
Simple and sturdy design and construction

Installation:

Simply decide where you want the divider to be located for your application
Place the divider in the chosen location

Ensure the notched end at the top fits around the spray bar that runs across the back of the tank
The divider is not meant to sit in between the ribs of the liner

It should sit on top of the ribs and have a snug fit

Occasionally the divider may be slightly oversized and difficult to fit.

In this case lightly sand the edges of the divider until it can be put in place.

Mark holes to be drilled
Drill two 5/16” holes
After drilling holes, fasten in place with included nuts and bolts.

Note: The set of three pre-drilled holes are used for the sound abatement cover attachment and are not meant for divider mounting

Download Instructions

*Note The Mr Deburr tanks have natural slight variations due to the urethane liner properties. For this reason the divider assemblies will not have an air or liquid tight fit. Very small millimeter sized medias or parts may pass through or become lodged between the divider and liner in some cases

Finishing Tank Accessories

Raytech Separating Screens

Related Products